Heat assisted recording on bottom layer of dual recording layer perpendicular magnetic recording media for two and a half dimensional (2.5D) magnetic data storage
Page view(s)
0
Checked on
Heat assisted recording on bottom layer of dual recording layer perpendicular magnetic recording media for two and a half dimensional (2.5D) magnetic data storage
Heat assisted recording on bottom layer of dual recording layer perpendicular magnetic recording media for two and a half dimensional (2.5D) magnetic data storage
In this paper, we present a study on two and a half dimensional (2.5D) perpendicular magnetic
recording (PMR) media consisting of dual hard magnetic recording layers (RL) with 1st or top RL1
used for conventional data storage and 2nd or bottom RL2 used for dedicated servo with lower
linear densities or DC servo patterns with focus on the writability issue of the bottom servo layer
(RL2). We demonstrate experimentally the feasibility to magnetically erase, write, and re-write
RL2 by laser assist on a home built heat-assisted-magnetic-recording writing test system.
Experimental data (by magnetic force microscopy measurements) show that the signal amplitudes
of the pre-recorded magnetic patterns for both RL1 and RL2 decrease at almost the same rate with
thermal erasure using scanning laser power (Pw) from 13 mW to 23 mW, clearly indicating equally
effective laser heating and close temperature rise for RL1 and RL2 for far field laser heating with
laser pulse duration in sub-ls and ls range. This is further verified by theoretical simulations of the
thermal distribution and the temperature rise depth profile in dual layer media by laser heating.
Simulations indicate very little temperature difference of less than 6K ( 1% of maximum temperature
rise) between RL1 and RL2 because the main mechanism of temperature rises in RL1 and RL2
is due to the effective thermal conduction from the top layers to lower layers. These experimental
and theoretical study results could provide useful understanding and insights into servo writing
methods of 2.5D PMR media.
License type:
PublisherCopyrights
Funding Info:
Description:
Copyright (2015) American Institute of Physics. This article may be downloaded for personal use only. Any other use requires prior permission of the author and the American Institute of Physics. The following article appeared in J. Appl. Phys. 117, 17C106 (2015) and may be found at http://dx.doi.org/10.1063/1.4907189.